Large multi-cavity molds are increasingly used in the field of electronic communication and technology molding to improve space output value and cost efficiency. Engel has paid attention to this trend in the field of application and is continuously enriching and expanding its full motor range, and the latest e-mac 280 will be exhibited at Fakuma 2017 for the first time!

It is reported that Engel e-mac 940/280 will demonstrate the production of connector housings at Fakuma. Usually, after the shell of the connector is completed by the injection molding process, it is also necessary to assemble the stabilizer liner, gasket and pin. Therefore, the injection accuracy and quality stability of the injection molding machine is an important factor in determining the competitiveness of the connector shell manufacturer. This can also explain why in the field of electronic product production, the whole motor is more popular!

When the audience at the Fakuma 2017 site, you can see Engel e-mac 940/280 produced with 40 pin holes in the connector housing, which requires a thinner support frame and a smaller thimble board inside the housing, and e-Mac full motor can meet the precision production of these thin-walled components.

Engel's latest e-mac 280, which will be exhibited for the first time at Fakuma 2017, is compact and affordable for the production of precision electronic and electrical components

Engel e-mac is also specially equipped with a powerful servo drive, and ejecting and mode-locking functions are also handled by electric servers. This guarantees the best accuracy and process stability while maximising the overall effect of the machine. The drive is operated in an operating shaft system with a stable intermediate circuit. Short cycles are achieved by parallel movement of the drive shaft.

With the help of the CC300 controller, the Engel e-mac injection molding machine is more flexible due to the integration of robots and additional peripherals, as well as the intelligent assistance system of the Engel inject 4.0 software.

The e-mac injection molding machine presented at Fakuma 2017 will use the following three systems: IQ weight control, which can be used to maintain the volume of melt during injection molding, thereby compensating for fluctuations caused by changes in environmental and raw material conditions; The iQ mode-locking control automatically calculates and adjusts the optimal mode-locking force based on the open mold exhaust; iQ flow control can reduce energy consumption control, and can be adjusted according to the temperature control of the mold.

Another advantage of the Engel e-mac series is the compact design, which saves space on the production floor. By using an optimized switching design, Engel has managed to effectively shorten the clamping mechanism of the new e-mac injection molding machine without reducing the opening stroke.

The first e-mac injection molding machine entered the market in 2012. Since then, Engel has been committed to meeting the various production requirements of all-electric injection molding machines. The Engel e-motion and e-cap series of high-performance injection molding machines are mainly used in high-speed injection molding and multi-component injection molding, such as in the medical and packaging industries, while the e-mac series offers a very affordable option for the electrical and electronic industries and technical injection molding.

Plastic Industry Video